SR EN 10025-6:2005

Hot rolled products of structural steels - Part 6: Technical delivery conditions for flat products of high yield strength structural steels in the quenched and tempered condition

Part 6 of this document, in addition to part 1, specifies requirements for flat products of high yield strength alloy special steels. The grades and qualities are given in Tables 2 to 4 (chemical composition) and Tables 5 to 7 (mechanical properties) and are supplied in the quenched and tempered condition as given in 6.3. The steels specified in this document are applicable to hot-rolled flat products with a minimum nominal thickness of 3 mm and a maximum nominal thickness L 150 mm for grades S460, S500, S550, S620 and S690, a maximum nominal thickness L 100 mm for grade S890 and a maximum nominal thickness L 50 mm for grade S960, in steels which, after quenching and tempering, have a specified minimum yield strength of 460 MPa ) to 960 MPa1).

General information

Status : Withdrawn
Approval date : 6/23/2005
Publish date : 6/24/2005
Withdrawal date : 11/30/2009
Number of pages : 28
ICS : 77.140.10 Heat-treatable steels,77.140.50 Flat steel products and semi-products
Technical Committee : 42 - Steels and ferroalloy

Relations with other standards:

Replaces SR EN 10137-2:1998
Normative reference SR EN 10048:1998
Normative reference SR EN 10025-1:2005
Normative reference SR EN 10020:2003
Normative reference SR EN 10164:2005
Normative reference SR EN 10051+A1:2000
Normative reference SR EN 10163-1:2005
Normative reference SR EN 10027-2:1996
Normative reference SR EN 10027-1:1996
Normative reference SR CR 10260:2000
Normative reference SR EN 10160:2001
Normative reference SR EN 1011-2:2002
Normative reference SR EN 10029:1995
Normative reference SR EN 10162:2003
Normative reference SR EN 10163-2:2005
Replaced by SR EN 10025-6+A1:2009