SR EN 754-7:1999

Aluminium and aluminium alloys. Cold drawn rod/bar and tube. Part 7: Seamess tubes, tolerances on dimensions and form

This part of EN 754 specifies the tolerances on dimensions and form for aluminium and aluminium alloy cold drawn seamless tubes with an outside diameter (OD) from 3 mm to 350 mm (round tube, see figure 1) or with a cross section contained within a circumscribing circle (CD) from 8 mm to 300 mm (other than round tube, see figure 2) supplied in straight lengths. This standard only applies to tube produced by the seamless die/mandrel method of extrusion (and then cold drawn to the final dimensions required).

General information

Status : Withdrawn
Approval date : 9/24/1999
Publish date : 9/25/1999
Romanian version publish date : 9/24/1999
Withdrawal date : 8/31/2008
Number of pages : 16
ICS : 77.150.10 Alluminium products
Technical Committee : 171 - Metals and non-ferrous alloys

Relations with other standards:

Replaces STAS 524/2-90
Replaced by SR EN 754-7:2008