SR EN 10326:2004

Continuously hot-dip coated strip and sheet of structural steels - Technical delivery conditions

1.1 This European Standard specifies requirements for continuously hot-dip coated products made of structural steels coated with zinc (Z), zinc-iron alloy (ZF), zinc-aluminium alloy (ZA), aluminium-zinc alloy (AZ) and aluminium-silicon alloy (AS) (see Table 1) with thicknesses from 0,35 mm up to 3,0 mm unless otherwise agreed (see 1.2). The thickness is the final thickness of the delivered product after coating. This European Standard applies to strip of all widths and to sheets cut from it (= 600 mm width) and cut lengths (< 600 mm width). 1.2 If agreed at the time of enquiry and order, this European Standard may also be applied to continuously hot-dip coated flat products in thicknesses > 3,0 mm. In this case the mechanical property, adhesion of coating and surface condition requirements shall also be agreed at the time of enquiry and order. 1.3 The products covered by this European Standard are mainly used where minimum yield strength and corrosion resistance are the most important factors. Corrosion resistance of the alloy is proportional to the coating thickness, hence to


Status : Withdrawn
Approval date : 11/12/2004
Publish date : 11/13/2004
Withdrawal date : 8/31/2009
Number of pages : 24
ICS : 77.140.10 Heat-treatable steels,77.140.50 Flat steel products and semi-products
Technical Committee : 42 - Steels and ferroalloy

Relations with other standards: