SR EN 10113-1:1995

Hot-rolled products in weldable fine grain structural steels. Part 1: General delivery conditions

1.1 This European Standard specifies requirement for long products and flat products of hot-rolled weldable fine grain structural quality and special steels. Part 1 of this European Standard specifies the general delivery conditions Part 2 of this European Standard specifies the delivery conditions for normalized steels in the grades and qualities given in table 1 (chemical composition) and tables 3 and 4 (mechanical properties) of part 2. NOTE: Whenever normalized is mentioned, normalized rolled is also covered (see 7.2 of part 2). Part 3 of this European Standard specifies the delivery conditions for thermomechanical rolled steels in the grades and qualities given in table 1 (chemical composition) and tables 3 and 4 (mechanical properties) of part 3. The steels specified in this European Standard are especially intended for use in heavily loaded parts of welded structures such as, bridges, flood gates, storages tanks, water supply tanks, etc., for service at ambient and low temperatures. 1.2 This European Standard doe

General information

Status : Withdrawn
Approval date : 1/30/1995
Publish date : 7/1/1995
Withdrawal date : 7/31/2006
Number of pages : 32
ICS : 77.140.10 Heat-treatable steels,77.140.20 Stainless steels
Technical Committee : 42 - Steels and ferroalloy

Relations with other standards:

Replaces STAS 9021/1-89
Replaced by SR EN 10025-1:2005
Replaced by SR EN 10025-3:2004
Replaced by SR EN 10025-4:2004